![]() Lots of FREE parking.Īll knives & scissors are sharpened on site by trained technicians by hand Our store front is located near Costco & Home Depot off Woodbine Ave south of Hwy 7 in Markham. They will now be ready for the next cut.Operating Hours Monday to Friday 11am to 430pm, Saturday 10am to 3 pm Run the Hair ClippersĪfter you reassemble the hair clippers, be sure to run the clippers for a few minutes. The oil also reduces friction that can damage the blades with continual use. The oil helps prevent the blades from overheating. That is the same oil you apply after every few cuts that you perform. Once you reassemble the hair clippers, add a few drops of hair clipper oil to the blades. Reattach the blades to the clipper base in the same position from the start. If the rust remains, then you will need to replace the blades. A solution with 90% alcohol should be sufficient. Then, soak them in a blade cleaning solution for a few minutes. If there are signs of visible rust on the blades. Then, you can clean the clippers with the same brush. That should remove any debris or shavings created from the sharpening process. ![]() Use an old toothbrush to brush the blade clean. If the blade is sharp enough on the first pass, you can move on to the cleaning and reassembly. This additional sharpening is an optional step. Again, move the blade across the stone at an angle and only in a forward direction. The sharpening stone for this result should have a grit surface of 8000. You can create an even sharper edge with a fine whetstone. Repeat the Sharpening process With a Fine Whetstone Repeat the process for the second blade after you sharpen the first blade. Then turn the blade over and repeat for the opposite side. The sharpening motion should yield a blade that is shiny and even. Repeat this forward motion for five to ten passes on the stone. In other words, you should not move the blade back and forth. It would be best if you only moved the blade forward. Move the blade at a 45-degree angle in a forward direction. Hold the stone in place on a flat surface. Look for a grit surface stone with a rating of 4000 to sharper hair clipper blades. You can find these stones in any hardware store. Run the Blade Across the Sharpening StoneĪ sharpening stone is also called a whetstone or a honing stone. You might want to wear surgical-type gloves to avoid injury. If you do not have a magnet holder, you can grip the blades for sharpening. ![]() It also helps prevent cuts and knicks to your fingers during sharpening. Attach the Blades to a Magnet HolderĪ specially designed magnet holder keeps the hair clipper blades in place while sharpening. ![]() That will help you remember how to reassemble the blades when the sharpening is complete. Pro Tip: There might be additional pieces holding the blades in place. Then pop off the blades from the clipper. Use the appropriate screwdriver (Philips or flathead) to remove the screws. Most blades are attached to the clippers with two screws located at the bottom of the blades. You have to remove your hair clipper blades before you can sharpen them. You can use the following eight steps to sharpen your hair clipper blades: 1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |